Serpent 411205 Precision Aluminum Servo Mount for S120L  [SER411205]

Serpent SER411205 Servo Mount Aluminium S120L (3)
Price:
NZD$46.94
Brand:
Serpent
Model:
SER411205
Condition:
Brand New
Write a review

Precision Servo Mount Made from Aluminium

Designed for the S120L chassis, the Serpent 411205 aluminium servo mount gives racers a dependable bracket to hold their servo exactly where it belongs. The machined aluminium body resists deformation so the servo stays true under load.

Lightweight Strength for Better Response

Using aluminium keeps mass down while providing a stiff mount that reduces flex. That stability translates into crisper steering transitions and steadier mid-corner behaviour.

Direct Compatibility with S120L

Engineered to match S120L mounting geometry, this Serpent 411205 fits into the chassis mounting points for an easy upgrade path. Installation is straightforward and requires minimal extra parts.

Specifications

  • Material: Aluminum
  • Compatibility: S120L Chassis
  • Pieces Included: 3

For club racers and weekend tuners looking to tighten steering precision on an S120L, this aluminium mount is a practical and lasting upgrade.

Can I fit this to older S120L versions?

Many S120L variants share the same servo mounting layout, but confirm your chassis year and revision before ordering to avoid surprises.

Does aluminium affect radio jitter or electronics?

Aluminium itself has no effect on radio signals. Ensure servos and receivers are properly mounted and isolated from grounding issues to avoid interference.

Are the included pieces enough for installation?

The pack includes three pieces as listed; check your servo and horn hardware to confirm all fasteners are present for a secure fit.

Any tips for setup after fitting the mount?

Re-centre the servo, verify steering endpoints, and do a small test run to confirm no binding before finalising trim and toe settings.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved