Serpent 411339 Carbon Center Pivot Bracket F110 SF2 Precision  [SER411339]

Serpent SER411339 Pivot Bracket Center Carbon F110 SF2
Price:
NZD$35.51
Brand:
Serpent
Model:
SER411339
Condition:
Brand New
Write a review

Precision Steering with Serpent Carbon Pivot

The Serpent 411339 Carbon Center Pivot Bracket is made for the F110 SF2 chassis to deliver crisper steering and better stability through corners. Its carbon makeup cuts mass while bolstering the rigidity of the car's suspension mounting points for a steadier ride.

Why Carbon Works for Racing

Carbon fiber combines low weight with high stiffness, a combination that helps reduce overall vehicle mass and keeps suspension geometry stable under load. These traits translate into more consistent lap times and easier chassis setup tuning.

Can I use this on a converted chassis

The bracket is intended for the F110 SF2 mounting pattern; converting it to other frames requires custom drilling or adapters.

Does it change weight distribution

It reduces local mass at the pivot area, which can slightly affect front to rear balance; drivers often adjust trim to compensate.

How should I maintain carbon parts

Keep the surface clean and inspect for cracks after heavy impacts; tighten hardware to spec and use threadlocker where recommended.

Will this affect suspension feel

Yes, increased pivot stiffness leads to a firmer suspension response and can make the car feel more direct over bumps and transitions.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved