Serpent 411382 Carbon Front Plate for F110 SF3 - Lightweight Race Part  [SER411382]

Serpent SER411382 Front Suspension Plate Carbon F110 SF3
Price:
NZD$50.83
Brand:
Serpent
Model:
SER411382
Condition:
Brand New
Write a review

Precision Carbon for Better Cornering

The Serpent 411382 Carbon Front Suspension Plate brings a firmer front end to the F110 SF3 without penalising agility. Constructed from quality carbon fiber, it reduces unwanted flex while keeping the front assembly light for quicker directional changes.

Why Go Carbon on the Front End?

Carbon fiber provides a superior stiffness-to-mass ratio, which helps the F110 SF3 react faster to steering inputs. The Serpent 411382 plate uses these properties to stabilise the chassis at mid and high cornering loads, improving consistency lap after lap.

Engineered for Clean Fitment

Made with the Serpent F110 SF3 geometry in mind, the plate offers straightforward installation and accurate alignment. The added rigidity enhances turn-in precision and helps keep tyre contact more uniform through varied track conditions.

Can I use this plate on other Serpent models?

This component is tailored for the F110 SF3's layout. While some Serpent parts share mounting geometry, you should verify hole positions and clearances before fitting it to a different model.

Will carbon change steering feel a lot?

Yes, carbon increases front-end stiffness which usually sharpens steering response and reduces progressive flex. Expect a crisper feel, which may require small setup adjustments to balance the car.

How should I maintain the carbon plate?

Keep it clean from grit and inspect edges after impacts. Tighten mounting screws to spec and replace the plate if you notice significant delamination or deep gouges.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved