Serpent 411386 - F110 SF3 Wide Front Suspension Kit  [SER411386]

Serpent SER411386 Wide front set F110 SF3
Price:
NZD$91.18
Brand:
Serpent
Model:
SER411386
Condition:
Brand New
Write a review

Upgrade your F110 SF3 with Serpent 411386 wide front geometry

The Serpent 411386 Wide Front Suspension Set is a race-focused upgrade built for the F110 SF3. It includes a 2mm carbon suspension plate, an expanded top-mounted castor plate and lightweight aluminium threaded track rods to increase front-end stability and reduce grip roll on tacky surfaces. The components are well suited to indoor carpet and sugar-treated tracks where small setup changes have big effects.

What the designer reported on track

Tested by David Ehrbar, ETS Series winner, the setup proved effective on his championship F110 SF3. Ehrbar reports improved predictability through corners without sacrificing traction. Installation matches the stock part procedure so no special modifications are needed.

Is this compatible with older F110 variants?

This kit was made for the SF3 spec of the F110. Older chassis may differ in mounting points so verify fitment before assuming interchangeability.

Should I change my camber or toe after fitting?

After fitting the wide front set, re-check toe and camber. Small adjustments to toe-in or front camber can help balance the altered steering response.

Does the carbon plate require special care?

The 2mm carbon suspension plate is durable but avoid overtightening fasteners. Inspect for any cracks after hard impacts and replace if damaged.

Can I run this on outdoor asphalt?

While it will fit, the biggest benefits are on high-traction indoor surfaces. On rough outdoor asphalt you may prefer a different setup tuned for surface irregularities.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved