Serpent SER411412 Rear Axle Aluminium Brace for F110 SF4  [SER411412]

Serpent SER411412 Rear axle holder L Aluminium F110 SF4
Price:
NZD$35.47
Brand:
Serpent
Model:
SER411412
Condition:
Brand New
Write a review

Stiffen the Rear End of Your Serpent F110 SF4

The Serpent SER411412 rear axle holder provides a rigid mounting point for the F110 SF4 rear axle. Made from durable aluminium, it improves structural integrity and keeps the rear geometry stable under load.

Why Choose Aluminium for the Axle Mount

Specifically produced for the Serpent F110 SF4, this axle holder replaces weaker plastic components and offers better resistance to wear. Its lightweight aluminium construction keeps mass low while delivering a noticeable improvement in durability.

Simple Workshop Fitment

Installing the Serpent SER411412 is a simple workshop job using common RC tools. Make sure fasteners are torqued to spec and recheck alignment after the first few runs to ensure consistent handling.

Does this change handling feel?

Yes, the added rigidity from the aluminium holder reduces flex at the rear which can sharpen the car's response, particularly under acceleration and corner exit.

Will I need different screws?

The part typically uses the same fixation points as the original, but confirm screw type and length before assembly and replace any worn fasteners.

Is there a weight penalty?

Aluminium adds some weight compared to plastic, but the trade off is increased durability and improved control that many racers prefer.

How do I maintain the aluminium mount?

Keep mating surfaces clean, inspect for burrs or damage after impacts, and ensure screws remain tight to avoid movement that can cause wear.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved