Serpent 421006 Replacement Ball-Joint Balls for S240 Series  [SER421006]

Serpent SER421006 Ball-joint Ball (10)
Price:
NZD$34.29
Brand:
Serpent
Model:
SER421006
Condition:
Brand New
Write a review

High-Precision Ball-Joint Balls for S240 Enthusiasts

The Serpent 421006 Ball-joint Ball pack contains ten accurately finished balls tailored to the S240 Electric Pancar family. They deliver consistent geometry to keep suspension articulation predictable and improve driver feedback on varied surfaces.

Designed to Handle Tough Running

These balls are produced from robust materials intended to resist wear from regular use and occasional knocks. Their durability means fewer changeovers and more time fine-tuning setup at the track or on the practice layout.

Simple Installation on S240 Chassis

Made for a direct fit into S240 linkages and steering components, these balls slot in easily without machining. That makes them useful spares for racers and hobbyists maintaining a reliable car setup.

Can I use Serpent 421006 on older S240 versions?

Most S240 variants share the same ball dimensions, so Serpent 421006 will usually fit older versions. Double check your parts diagram to confirm compatibility.

Should I lubricate the ball-joints?

A light application of suitable suspension grease can reduce wear and noise. Avoid over-greasing which can attract grit in outdoor running.

Are these sold as individual balls?

This product is supplied as a set of ten balls. Check with your supplier for single-item availability or alternative pack sizes.

What should I inspect when replacing them?

When fitting new balls inspect cups, pins and retaining clips for wear or deformation to ensure no premature play develops after the swap.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved