Serpent 421025 10T Pinion for S240 Electric Pancar [SER421025]

Price:

NZD$12.49

Brand:

Serpent

Model:

SER421025

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Refine Drive Response with the Serpent 421025 10T

The Serpent 421025 10T Pinion Gear is built to enhance the driveline of S240 series electric pancars, giving smoother acceleration and dependable engagement. Quality machining helps maintain consistent performance lap after lap.

Highlights of the 10T Pinion

Compatibility: Specifically matched to S240 model geometry for straightforward installation.
Durability: Tough construction is intended to handle the demands of club and club-level racing.
Performance Tuning: A 10-tooth design that helps tune torque delivery without sacrificing controllability.

When to Fit the Serpent 10T

Fit the Serpent 421025 when you need a reliable replacement or when changing gearing to suit a different track. It is a practical choice for hobbyists who tweak ratios to balance acceleration and top speed.

Will this pinion need shimming or spacers to fit?

Most S240 setups accept the Serpent 421025 without extra spacers, but check motor position and use shims if needed to get the correct mesh and alignment.

How often should I inspect the pinion for wear?

Inspect the teeth after every few race meetings or after any unusual noise under load. Replace if teeth show rounding or significant wear to avoid spur damage.

Can I change tooth count for different tracks?

Yes, swapping to a different pinion tooth count is a common tuning method. Use the Serpent 421025 as a baseline and experiment with larger or smaller pinions to suit grip and layout.

Is any special lubricant recommended for the gears?

Light gear grease on the spur root can reduce noise and wear, but avoid heavy greases that attract dirt. Keep mesh clean and re-check periodically.