Serpent 421038 Carbon Shockplate Spacer S240 Series Race Part  [SER421038]

Serpent SER421038 Shockplate Spacer Carbon
Price:
NZD$6.34
Brand:
Serpent
Model:
SER421038
Condition:
Brand New
Write a review

Dial In Precision with Serpent 421038

RC builders wanting more exact shock settings for their S240 pan car will find the Serpent 421038 Carbon Shockplate Spacer useful. Fabricated from quality carbon, this spacer aims to reduce unwanted flex while keeping mass low for sharper handling.

Neat Fit for S240

Designed to sit correctly in S240 chassis layouts, the Serpent 421038 Carbon Shockplate Spacer integrates without fuss. Its carbon panel increases local stiffness, helping the suspension maintain intended geometry under load.

Material Advantages

Carbon fibre is chosen for its resistance to bending under stress and minimal weight penalty. This spacer helps the car deliver repeatable steering and more consistent behaviour during a run.

Precision for Setup Work

From testing different shock positions to replacing worn parts, the Serpent 421038 supports careful setup work. Consistent mounting and robust construction make it a stable base for fine adjustments.

Can I use this spacer with aftermarket shock towers?

It will work with towers that share the S240 mounting pattern. Confirm hole spacing and thickness to avoid misalignment before installing.

Does carbon change drivetrain stress?

The spacer itself has minimal effect on drivetrain loads, but stiffer suspension mounting can change traction transfer. Monitor drivetrain parts during setup changes.

How do I clean and care for the spacer?

Wipe with a damp cloth to remove grime and avoid solvents that could damage adhesives. Inspect edges and holes for wear after each hard session.

Any tuning advice when fitting this part?

Start with factory settings and make small shock height or spring rate changes. Track tests will reveal whether you need stiffer or softer configurations.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved