Serpent SER440107 Upper Arm - Direct-Fit for Mini Spyder Monster truck (SER440001) [SER440107]

Price:

NZD$14.70

Brand:

Serpent

Model:

SER440107

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Fit and installation notes for the upper arm

The Serpent SER440107 upper arm is provided as a replacement upper suspension arm compatible with the Mini Spyder Monster truck RTR EP (SER440001). It is intended as a serviceable part for maintenance and tuning, not presented as an aftermarket performance enhancement.

In use, the upper arm positions the upper hub and contributes to camber and roll centre behaviour that influence the truck's suspension geometry. When installing a replacement, align it with the lower arm and hub carrier to preserve the intended steering geometry and suspension motion.

Installation tips: confirm the correct orientation of the arm, secure the mounting fasteners to the original points, check for interference through full suspension travel, and examine ball stud and pivot joints for looseness. This description treats the component as an RC maintenance item for model-scale tuning tasks.

Which tools do I need to fit the SER440107 upper arm?

Basic hand tools used for the Mini Spyder suspension are sufficient: small hex drivers or nut drivers to remove and reinstall the original fasteners, and a caliper or ruler to check alignment if needed.

Are any alignment adjustments required after replacing the arm?

After fitting, verify toe and camber settings and make minor adjustments if the hub carrier position differs; the aim is to return the chassis to its factory geometry.