Serpent SER440123 Rear Support for Mini Spyder MT [SER440123]

Serpent SER440123 Wheelie bar Mini Spyder MT

Price:

NZD$14.70

Brand:

Serpent

Model:

SER440123

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Mini Spyder MT rear support wheelie bar

The Serpent SER440123 wheelie bar is an RC-scale accessory built for the Mini Spyder MT platform. Its purpose is to control rear geometry under high throttle and reduce sudden nose-up behaviour when launching or accelerating out of loose corners.

This unit bolts to the rear of the Mini Spyder MT chassis using the intended mounting points and forms a support surface behind the driven wheels. Properly adjusted for height and angle it helps keep the vehicle level during throttle bursts without requiring motor or ESC changes.

Use this bar as part of your setup routine: raise it for more dramatic wheelies, lower it to cut nose lift earlier. Regularly check fasteners and confirm clearance so the bar does not contact the ground or restrict suspension movement during heavy landings.

Will the SER440123 completely prevent nose-up on takeoff?

No single part will fully eliminate nose lift, but the SER440123 significantly reduces excessive front rise by limiting how far the chassis can tip back under hard acceleration.

How should I set the bar for track versus casual use?

For tighter, competitive tracks lower the bar to stop lift earlier; for casual bashing raise it to allow controlled wheelies. Fine-tune incrementally and test under real throttle conditions.