Serpent 500131 Rear Bulkhead for SRX2 RM Chassis - Track Ready Replacement  [SER500131]

Serpent SER500131 Bulkhead Rear SRX2 RM
Price:
NZD$11.87
Brand:
Serpent
Model:
SER500131
Condition:
Brand New
Write a review

Upgrade Rear Stability with the Serpent 500131 Bulkhead

For drivers who demand consistent handling from their SRX2 RM, the Serpent 500131 Rear Bulkhead restores proper rear support and keeps the suspension geometry true. It is a practical part for regular servicing and race preparation.

Designed to Keep Rear Geometry True

The rear bulkhead secures the rear suspension mounts and helps the chassis resist flex that can upset handling. Serpent has focused on accuracy in the locating points to maintain predictable behaviour under load.

Careful Fitment for a Clean Installation

This bulkhead is made to match the Serpent SRX2 RM mounting layout so it fits with minimal fuss. It is suitable for swapping out old or damaged components and should install with routine hobby tools.

Can Serpent 500131 be used on modified SRX2 RM builds

Yes, it fits standard SRX2 RM layouts. If your car has aftermarket alterations to the rear bulkhead area, check clearance before fitting.

Is any prep needed before installing a new bulkhead

Clean the mounting faces and inspect screws for wear. Light degreasing and replacing old fasteners will help ensure a secure fit.

Will replacing the bulkhead change handling significantly

If the previous bulkhead was worn or damaged, you may notice crisper rear response. Otherwise the part restores factory geometry rather than changing core handling.

Where should I store spare bulkheads between races

Keep spares in a dry parts box away from direct sunlight and solvents to avoid warping or degradation over time.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved