Serpent 500154 SRX2 Replacement Idler Shaft - Racing Spec  [SER500154]

Serpent SER500154 Idler Gear Shaft SRX2
Price:
NZD$12.44
Brand:
Serpent
Model:
SER500154
Condition:
Brand New
Write a review

Refine SRX2 Drivetrain Performance with Serpent 500154

The Serpent 500154 Idler Gear Shaft is designed as a reliable replacement for SRX2 racers who demand consistent drivetrain behaviour. It focuses on precise alignment and dependable operation to keep your car predictable on tight circuits.

Advantages for Drivers

Fitting this idler shaft improves gear stability and helps limit play in the drivetrain during hard cornering. Its design integrates with the SRX2 geometry to support durable, repeatable performance across sessions.

Simple Installation Hints

Installing the Serpent 500154 Idler Gear Shaft is a straightforward task for most enthusiasts. Clean contact points, verify proper seating, and adjust gear mesh before the first run to ensure optimal results.

Can I use this shaft on older SRX2 revisions?

The Serpent 500154 targets the SRX2 specification. Compatibility with older revisions depends on any changes to mounting points or clearances, so check your chassis details before fitting.

Will installing this shaft affect gear mesh?

If installed correctly, the shaft should maintain intended gear mesh. Always verify the mesh and make minor adjustments to the idler position if needed for smooth operation.

Is special tooling required to fit the shaft?

Standard RC workshop tools are typically sufficient. Take care to handle bearings and retaining hardware carefully to avoid introducing play.

How should I check shaft condition?

Look for wear marks, bends, or scoring and check that gears run true. Replace the shaft if you notice excessive wear or wobble during rotation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved