Serpent 500188 - SRX2 RM Battery Foam Inserts 6pcs Performance Set  [SER500188]

Serpent SER500188 Battery Case Inserts Foam (6) SRX2 RM
Price:
NZD$21.36
Brand:
Serpent
Model:
SER500188
Condition:
Brand New
Write a review

Improve Battery Security on SRX2 RM

Modelers who demand a snug battery hold will appreciate the Serpent 500188 foam inserts. Purpose built for the SRX2 RM layout, the kit contains six foam parts so you can adapt padding to different battery footprints and balance needs.

Vibration Control and Pack Safety

Made from durable foam material, the inserts help isolate the battery from chassis vibration and impacts, reducing wear on terminals and connectors. This cushioning supports steadier electrical output during rough track conditions.

Fitment That Saves Time

These inserts are shaped to drop into the SRX2 RM battery compartment with little fuss. Adjustment and replacement are quick, making it simple to switch battery types between test runs and events.

Are the inserts pre-cut for common battery sizes?

The pads come as six generic pieces for flexible placement rather than pre-cut shapes. You can trim them if you need a custom fit.

Will the foam compress over time?

Some compression is normal after extended use. Inspect pads periodically and replace if they become flattened and no longer secure the pack.

Do these inserts affect weight distribution?

Minimal weight is added, but pad placement can help fine tune pack position for handling balance. Position pads to suit your setup.

Is adhesive required to hold the foam in place?

The foam usually stays put inside the compartment, but a small amount of double sided tape can be used for a permanent fit.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved