Serpent 500262 TiN Coated Pivot Pins SRX2 Upgrade Kit  [SER500262]

Serpent SER500262 Pivot pin Front Inner / Rear Outer TiN Coated (2) SRX2
Price:
NZD$16.96
Brand:
Serpent
Model:
SER500262
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Upgrade SRX2 Suspension with TiN Pivot Pins

The Serpent 500262 pivot pin kit brings a titanium nitride finish to the SRX2 pivot points, extending service life and reducing surface wear. Specifically made for the front inner and rear outer positions, these pins help keep suspension geometry consistent.

Low Friction, High Hardness

TiN is prized for its hard, slick surface which reduces metal-on-metal abrasion. That combination reduces play over time and helps the suspension operate smoothly through repeated cycles.

Precision Fit for Track Use

Built to tight tolerances for race applications, the Serpent 500262 pins promote predictable suspension movement and stable handling at speed. That consistency aids setup tuning and driver confidence.

Installation Notes

  • Remove any old grease and debris from pivot housings before installation.
  • Apply a small amount of light oil to ease initial movement.
  • Check pins periodically for signs of wear and change them if movement becomes sloppy.

Do Serpent 500262 pins require a break-in period?

A short break-in with light lubrication will seat the coating and smooth initial friction. Run a few easy laps and then recheck movement and lubrication levels.

Can I use these pins on track exposed to dirt?

TiN improves wear resistance but dirt still accelerates wear. Keep pivot areas shielded where possible and clean more often after dusty or muddy running.

Will these pins reduce suspension play?

If your chassis is set up correctly, the harder TiN surface helps maintain tight clearances and reduces the development of play over time compared to untreated pins.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved