Serpent 500346 SRX2 Antirollbar Wire Adaptors - Setup Tweak Pack  [SER500346]

Serpent SER500346 Antirollbar Wire Adaptors (2+2) SRX2
Price:
NZD$8.44
Brand:
Serpent
Model:
SER500346
Condition:
Brand New
Write a review

Precise roll tuning for SRX2 chassis

The Serpent 500346 SRX2 Antirollbar Wire Adaptors are tailored for RC hobbyists who want to refine handling on the SRX2 platform. These adaptors let you make measured changes to anti-roll bar geometry so your car tracks truer through corners.

Tweak handling with confidence

Produced to fit securely, the adaptors enable predictable adjustments that help balance grip and responsiveness. Their robust construction keeps them working reliably across multiple practice sessions and club meets.

Fast installation and compatibility notes

Designed for direct fitment to the SRX2 chassis, these wire adaptors do not need extra trimming or drilling. Supplied as a set of four, they provide everything required for a full swap or upgrade of worn linkage parts.

Can I use these on older SRX2 variants?

Most SRX2 iterations share mounting layouts, but double check hole spacing and link length before fitting to older chassis revisions.

Do these change ride feel on loose surfaces?

Yes, adjusting the adaptors can alter roll control which affects grip transitions on loose or low-grip surfaces, helping you tune for traction.

Are special tools required to fit them?

Standard hobby tools are sufficient for installation; no special fixtures are required to swap the wire adaptors on the SRX2 chassis.

Will they affect maintenance intervals?

Properly fitted adaptors reduce side play in the linkage and can help slow wear, but regular inspection is still recommended after heavy running.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved