Serpent 500497 SRX Caster Shim 1mm Precision Pack  [SER500497]

Serpent SER500497 Casterblock Shim 1mm (4) SRX
Price:
NZD$7.24
Brand:
Serpent
Model:
SER500497
Condition:
Brand New
Write a review

Dial-In Caster with Serpent 500497 Shims

The Serpent 500497 1mm shim set is a handy tuning tool for SRX chassis geometry. These shims enable accurate caster tweaks so you can refine steering characteristics for different surfaces.

Caster Angle Tweaks

Specifically matched to SRX casterblocks, the 1mm thickness gives fine-grain adjustment to steering response and stability. Use small changes to test handling without disrupting other setup parameters.

Built for Repeated Use

Serpent manufactures these shims to resist wear from frequent adjustments, delivering dependable performance over many setup sessions. They are a practical part for serious weekend tuners.

What basic tools do I need to fit these shims?

A small socket or hex driver to remove the casterblock fasteners, plus a clean work area, is enough to fit these 1mm shims accurately.

Will these shims change tyre wear patterns?

Minor caster adjustments can influence steering and load distribution, so check tyres after setup changes and adjust camber or toe if needed.

Can I remove the shims later without damage?

Yes, the shims are removable; keep screws and surfaces clean when reinstalling to maintain consistent alignment settings.

Do these affect other suspension settings?

Changing caster can slightly alter steering balance, so recheck toe and camber as part of a full setup session after fitting the shims.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved