Serpent 500506 3-Gear Transmission for SRX2 MH - Precision Upgrade  [SER500506]

Serpent SER500506 Upgrade-set 3-gear Trans SRX2 MH
Price:
NZD$5.78
Brand:
Serpent
Model:
SER500506
Condition:
Brand New
Write a review

Refine your SRX2 MH with the Serpent 500506 transmission

The Serpent 500506 3-Gear Transmission Upgrade is a targeted improvement for the SRX2 MH chassis that tightens drivetrain behavior and improves robustness. It helps deliver a more consistent power curve and better handling feel under load.

Precision Machining for Consistent Performance

Components are precision-cut to minimise backlash and lower friction, which contributes to more direct drive response and longer service intervals. The construction is aimed at hobbyists who push setups during club and regional racing.

Compatibility Tips and Setup

Made to mate with SRX2 MH parts, the transmission mounts in place of the stock unit with a straightforward installation. Double-check bearing seating and gear mesh, and confirm alignment to avoid premature wear.

Can I fit this to other Serpent chassis?

This set is tailored for the SRX2 MH geometry. Other Serpent models will likely need adapter parts or will not align without modification.

What maintenance does the upgrade need?

Keep gears clear of grit, check for loose fasteners, and replace worn bearings. Regular inspections after racing sessions will keep things reliable.

Will it affect handling balance?

The upgrade reduces drivetrain loss and can make throttle transitions feel sharper, which may require small setup adjustments to maintain balance.

Are special tools required to fit the kit?

Basic RC tools and a torque driver are sufficient for most installations. Use proper bearing presses or drivers to avoid damage when seating bearings.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved