Serpent 500542 - SRX2 Rear Long Driveshaft Set Circuit Ready  [SER500542]

Serpent SER500542 Driveshaft Rear Long (2) SRX2
Price:
NZD$39.60
Brand:
Serpent
Model:
SER500542
Condition:
Brand New
Write a review

Upgrade the SRX2 drivetrain with Serpent 500542

RC drivers seeking better drivetrain durability will find the Serpent 500542 - SRX2 Rear Long Driveshaft Set a sensible upgrade for technical tracks. It is tailored for the SRX2 and helps deliver more consistent torque to the rear wheels.

Built for Consistent Track Performance

These rear long driveshafts from Serpent are produced to withstand repeated race conditions and keep the SRX2 stable under acceleration. Their solid construction contributes to predictable handling lap after lap.

Straightforward Fit for SRX2 Chassis

The driveshafts are made to match SRX2 geometry, providing a direct fit that simplifies replacement. Hobbyists can complete the swap with basic tools and minimal setup time.

Are these shafts compatible with converted SRX2 layouts?

They are designed around standard SRX2 dimensions; if your car has modified bulkheads or uprights, double check clearances before fitting.

What routine checks should I perform after fitting?

After installation, verify pin retention, rotate the drivetrain to check for binding, and recheck hardware torque after a few runs.

Can I run these on mixed surfaces like gravel and asphalt?

They handle mixed surfaces well but frequent grit exposure calls for more regular cleaning and inspection to prevent premature wear.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved