Serpent 500612 SDX Front Sway Bar 1.2mm - Precision Setup [SER500612]

Serpent SER500612 Antirollbar Front 1.2mm SDX

Price:

NZD$8.69

Brand:

Serpent

Model:

SER500612

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Fine tune SDX steering with Serpent 500612

The Serpent 500612 front sway bar is manufactured at 1.2mm thickness to tighten turn-in and reduce unwanted roll on the SDX chassis. Its front location helps balance grip and steering predictability during aggressive laps.

Durable design for consistent laps

Engineered for track use, the Serpent 500612 holds up under repeated corner loads while maintaining consistent flex characteristics. It installs to SDX-specific mounts and is useful for drivers seeking repeatable handling through a stint.

Is this compatible with older SDX variants?

The 500612 is produced for SDX series geometry. Many older SDX variants share similar mounts, but check your chassis points and clearances before fitting.

Will it make the car oversteer?

A stiffer front bar reduces roll and can increase front bite, which may reduce understeer. Effects depend on the overall setup, so tune progressively alongside rear bar and tyre choices.

How often should I check it?

Inspect mounting points and link hardware regularly for wear or play, especially after hard sessions. A quick check between heats keeps handling consistent and prevents unexpected failures.