Serpent 500659 Spyder SDX4 EVO Front Wishbones V2 Pair  [SER500659]

Serpent SER500659 Wishbone Front V2 Left + Right SDX
Price:
NZD$19.03
Brand:
Serpent
Model:
SER500659
Condition:
Brand New
Write a review

Balanced Front Arms for Competitive Buggies

Fit the Serpent 500659 Wishbone Front V2 Left + Right to your Spyder SDX4 EVO to improve front-end stability. These suspension arms are engineered to maintain correct geometry while resisting routine race damage, helping the buggy remain balanced through jumps and rough sections. Ideal for racers wanting a dependable replacement that keeps setup consistent.

Designed for Consistent Handling

The front wishbones use quality-grade materials to provide longevity and consistent flex characteristics. Their V2 profile helps the suspension articulate smoothly while preserving predictable steering feedback across different surfaces.

Quick Replacement and Chassis Compatibility

These wishbones are made to slot into the Spyder SDX4 EVO chassis without modification, allowing straightforward installation with existing hardware. They are a practical option to restore factory alignment and get the car back to competition quickly.

Can I use these on older SDX variants?

The Serpent 500659 was produced for the SDX4 EVO. Fit on older SDX models depends on the arm pivot spacing and mount points, so verify dimensions before fitting.

What maintenance do these wishbones need?

Regularly check for hairline cracks and wear around the pivot areas, keep mounting screws tight, and replace the arms if you notice play or deformation after heavy use.

Are any setup changes required after fitting these arms?

In most cases the Serpent 500659 installs as a direct replacement and preserves existing geometry, but check camber and toe after installation to confirm alignment.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved