Serpent SER500666 Rear Inner Pivot Pin Set SDX4 Upgrade  [SER500666]

Serpent SER500666 Pivot pin Rear Inner V2 (2) SDX4
Price:
NZD$16.94
Brand:
Serpent
Model:
SER500666
Condition:
Brand New
Write a review

Rear Inner Pivot Pin Upgrade for SDX4

RC drivers wanting dependable rear suspension should consider the Serpent SER500666 Rear Inner Pivot Pin Set for the SDX4. These pins secure the rear arms to the chassis and help keep handling consistent during fast laps.

Resilient Construction for Trail Use

Manufactured to resist wear, the pins are suited to rough surfaces and frequent impacts. They are a sensible upgrade when stock components start showing signs of fatigue.

Accurate Alignment for Better Handling

The precision of the Serpent SER500666 fit reduces unwanted movement in the rear end, helping the SDX4 maintain alignment and predictable suspension behaviour.

Can I reuse my existing bushings with these pivot pins?

In most cases existing bushings will work, but inspect them for wear and replace if they show play to keep the assembly tight.

Are any modifications needed to fit the SER500666 on an SDX4?

No modifications are typically required; the pins are cut to match SDX4 mounting points and should drop in with standard hardware.

Which driving conditions benefit most from these pins?

Rough off-road tracks and hard cornering sessions benefit most, since the pins reduce flex and wear compared to basic replacements.

How should I maintain the pivot area for longevity?

Clean the area after runs, apply light lubricant where recommended and check for movement; replacing pins at first signs of distortion keeps handling consistent.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved