Serpent 500672 Front CVD Axle Set for SDX4 - Club Racer Choice  [SER500672]

Serpent SER500672 CVD Wheel Axle set Front (2) SDX4
Price:
NZD$90.75
Brand:
Serpent
Model:
SER500672
Condition:
Brand New
Write a review

Precision Front CVD Axles Tailored for the SDX4

The Serpent 500672 Front CVD Wheel Axle Set is crafted for SDX4 buggies to improve toughness and steering precision. The set supplies two front axles engineered to withstand frequent running and varied track surfaces.

Built to Withstand Demands of Racing

These CVD axles use sturdy construction to limit wear and keep alignment stable during aggressive driving. The design helps reduce maintenance intervals while keeping handling predictable.

Better Steering Feedback for Consistent Laps

Fitting this axle set to an SDX4 sharpens steering response and improves front-end stability for repeatable lap times. It is a straightforward upgrade for drivers who want clearer front feedback.

Will these work with older SDX4 kits?

They are intended for SDX4 platforms; earlier kit variants that keep standard front hub dimensions should accept them, but check your parts list to be sure.

What lubrication is recommended?

Use a light, high-quality grease on the CV interfaces and inspect seals after wet or sandy runs to maintain smooth operation.

Are these suitable for loose or hard-packed surfaces?

Yes, the Serpent 500672 axles were made to handle a variety of surfaces while preserving steering precision and overall durability.

How difficult is the installation?

Installation is generally straightforward for hobbyists familiar with front-end work; basic tools and a service manual or guide for the SDX4 are recommended.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved