Serpent SER500678 Spyder Gen3 2WD Lightweight Shell  [SER500678]

Serpent SER500678 Body Spyder gen3 2wd 1/10
Price:
NZD$76.34
Brand:
Serpent
Model:
SER500678
Condition:
Brand New
Write a review

Race-Ready Shell for 1/10 Off-Road Cars

The Serpent SER500678 Spyder Gen3 2WD body delivers a clean balance of toughness and low weight for 1/10 off-road hobbyists. Its contouring suits competitive environments where control and resilience matter.

Chassis Fit and Airflow

Compatible with a broad range of 1/10 off-road frames, the Spyder Gen3 integrates smoothly without complex mods on many setups. The shaped bonnet and flanks help channel air for steadier handling at speed.

Robust Polycarbonate Performance

Constructed from quality polycarbonate, this body resists scuffs and impacts while remaining light enough to preserve the vehicle's handling characteristics on twisty or rough circuits.

Specifications

  • Scale: 1/10
  • Type: 2WD Off-Road
  • Material: High-Quality Polycarbonate

The Serpent Spyder Gen3 2WD is a practical upgrade for hobbyists aiming to refine on-track manners and keep a neat, durable appearance across varied off-road conditions.

How do I check if the body mounts align with my chassis?

Measure your current body mount spacing and wheelbase, then compare against the Spyder Gen3 placement. A cardboard mockup can speed this check.

Is this body heavy or light compared to stock shells?

The polycarbonate construction keeps weight low while offering good impact resistance, so it tends to be lighter than older, thicker shells used for casual bashing.

Can I mount wing or body accessories?

Yes, there is room to fit small wings and lightweight accessories. Secure fittings with proper mounting hardware to avoid stress points on the polycarbonate.

What upkeep keeps the shell lasting longer?

Avoid harsh solvents when cleaning, repair deep cuts with tape or patches on the inside, and touch up paint only with polycarbonate-safe products.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved