Serpent 500736 Carbon Shock Tower SRX2 Gen3 - Track Focused Upgrade  [SER500736]

Serpent SER500736 Shocktower Front Gull arm Carbon SRX2 Gen3
Price:
NZD$40.87
Brand:
Serpent
Model:
SER500736
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Fit a Carbon Shock Tower to Your SRX2 Gen3

The Serpent 500736 offers a tailored carbon upgrade for SRX2 Gen3 owners who prioritise balance and feel. Its carbon construction cuts weight at the top of the suspension and sharpens turn-in without compromising strength during repeated running.

Why Carbon Helps Handling

Carbon reduces unwanted flex and concentrates stiffness where suspension pivots need it most. Installing the Serpent 500736 refines feedback to the driver and helps maintain consistent suspension geometry lap after lap.

Straightforward Installation

Designed to match SRX2 Gen3 mounting points, the Serpent 500736 fits into place with standard hardware. The close fit means minimal setup time so you can fine tune springs and damping sooner.

Is any special prep required before fitting the Serpent 500736?

Check that mounting holes are clear of debris and that your screws match the recommended lengths. A quick trial fit will confirm alignment before final tightening.

Does this tower change suspension geometry?

No geometry changes are expected when replacing like for like, but the stiffer top mount can alter feel, so small setup tweaks may be beneficial.

Can I use existing hardware from my alloy tower?

Often the same screws will work, but confirm lengths and thread types before reuse. Replace damaged fasteners to protect the carbon surface.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved