Serpent 500742 Front Sway Bar 1.0mm for SRX2 Gen3  [SER500742]

Serpent SER500742 Antiroll bar 1.0 Front SRX2 Gen3
Price:
NZD$9.53
Brand:
Serpent
Model:
SER500742
Condition:
Brand New
Write a review

Refine Corner Grip on SRX2 Gen3

The Serpent 500742 front antiroll bar at 1.0mm offers targeted tuning for the SRX2 Gen3, helping reduce excessive roll and sharpen front-end reaction. Its profile gives a useful mix of rigidity and compliance for consistent lap times.

Track-Proven Construction

Manufactured to withstand frequent running, this Serpent front bar keeps its behaviour under race conditions. The precise form lets you tweak suspension balance and reduce unpredictable body movement through fast bends.

Quick Fit Installation

Built to sit into the SRX2 Gen3 layout, the Serpent 500742 is easy to fit and requires only minor link adjustments to set the front roll rate. Small tuning moves change handling quickly to suit the circuit.

What surface conditions suit a 1.0mm bar?

A 1.0mm wire works well on medium to high grip surfaces where you want less body lean and more direct steering response without making the front too harsh.

How does it interact with front dampers?

Pairing the bar with softer front damping smooths feedback, while firmer shocks accentuate the roll control. Adjust both together when tuning for balance.

Can I swap to a different diameter easily?

Changing wire diameter is straightforward if you have the matching endlinks and mounts; altering diameter is a common way to tune handling across tracks.

What routine checks should I do after fitting?

Check link tightness, inspect for play in mounts, and run a few slow test laps to confirm roll characteristics before competitive running.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved