Serpent 500745 - SRX2 Gen3 Rear Antiroll Bar 1.2 Precision Setup  [SER500745]

Serpent SER500745 Antiroll bar 1.2 Rear SRX2 Gen3
Price:
NZD$9.53
Brand:
Serpent
Model:
SER500745
Condition:
Brand New
Write a review

Rear Roll Upgrade for SRX2 Gen3 Handling

The Serpent 500745 antiroll bar is a 1.2mm rear option made for the SRX2 Gen3 chassis to improve lateral stability and reduce unwanted rear sway. It helps drivers dial in a controlled rear end for more consistent lap times.

Sharper Turn-In on Technical Tracks

Built to resist deformation under load, this antiroll bar enhances rear tyre contact during mid-corner phases and provides a firmer platform for progressive steering inputs. It is useful when you need sharper response through chicanes and quick transitions.

Compatibility and Fit

Fitting the Serpent 500745 to the SRX2 Gen3 is direct and uncomplicated, matching the platform's rear mounting layout and working alongside Spyder Series components. Quick changes between bar sizes let you adapt to different track surfaces between sessions.

Should I change droop when fitting the 1.2 bar?

Small droop adjustments can complement the stiffer rear bar. Reducing rear droop slightly often helps regain compliance and maintains traction over bumps.

Is this suitable for carpet and asphalt tracks?

Yes, the Serpent 500745 works on both carpet and asphalt, but you may need different front/rear roll balance to suit each surface.

Can I bend this bar to tune it?

The part is precision made and not intended to be bent. Use different bar diameters or link settings to alter stiffness rather than reshaping the bar.

Will it affect front steering feel?

Increasing rear stiffness can influence front feel, often making the car turn in quicker. Balance both ends when tuning to avoid snap oversteer.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved