Serpent 500749 - SRX2 Gen3 Lightweight Aluminum Suspension Bracket  [SER500749]

Serpent SER500749 Suspension Bracket mid Rear-Rear Aluminium SRX2 Gen3
Price:
NZD$65.79
Brand:
Serpent
Model:
SER500749
Condition:
Brand New
Write a review

Purpose-Built Aluminum Bracket for SRX2 Gen3

The Serpent 500749 - SRX2 Gen3 bracket is a carefully produced mid rear-rear component made to match the SRX2 Gen3 chassis. Crafted from premium aluminum, it preserves chassis geometry while resisting the stresses of competitive racing.

Strength Without Excess Weight

Aluminum construction gives this bracket good wear resistance while keeping mass down to help maintain correct weight distribution. That balance improves cornering consistency and responsiveness on varying surfaces.

Seamless SRX2 Gen3 Upgrade

Made to the SRX2 Gen3 mounting specification, this bracket installs cleanly with standard hardware and is a direct replacement for worn or damaged parts. It is a practical upgrade for hobbyists focusing on setup refinement.

Can I use this on non SRX2 models?

This bracket is designed around SRX2 Gen3 dimensions. Using it on other models may need drilling or adapters to align mounting points.

Does the aluminum affect handling?

The lower weight of aluminum helps keep mass centralised and can yield crisper response compared to heavier replacement parts, while still adding strength.

Is any prep required before fitting?

Light cleaning of mating faces and thread locking where appropriate is recommended. Verify screw lengths to avoid interference with suspension travel.

How often should I replace the bracket?

With normal use the bracket lasts a long time; replace if you see bending, crack starts, or if mounting holes become elongated.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved