Serpent 500774 - SRX2 Gen3 Low Wide Rear Wing Performance Wing  [SER500774]

Price:
NZD$17.34
Brand:
Serpent
Model:
SER500774
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Tune Aerodynamics with a Low Wide Rear Wing

RC drivers wanting cleaner airflow at the rear will find the Serpent 500774 rear wing an effective upgrade. It is designed around the SRX2 Gen3 platform and carries the Spyder Series fitment approach for straightforward installation.

Aerodynamic Gains for Corner Work

The low wide profile produces usable downforce without adding needless drag, helping the car stick into the corner and remain stable through the exit. The broad span helps control turbulent air behind the body for more predictable handling.

SRX2 Gen3 Fitment and Quick Setup

Tailored for SRX2 Gen3 mounts, the wing bolts on with minimal fuss. After fitting, adjust the angle in small steps to match track conditions and driving style.

How hard is this to fit to my SRX2 Gen3?

Installation is simple for most hobbyists; the wing uses the SRX2 Gen3 mount layout so no trimming is normally required.

What angle should I start with?

Begin with a modest angle and perform test runs, increasing angle in small increments until you find the best balance between grip and straight line stability.

Does the wing need special maintenance?

Keep an eye on mounting hardware and check the wing for cracks after impacts; replace if structural integrity is compromised.

Is this suited to loose surfaces?

The wing is tuned for paved track use where downforce aids grip; benefits on loose or gravel surfaces will be limited.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved