Serpent 69mm Rear Driveshaft for SRX2 Gen3 - Precision Upgrade [SER500784]

Serpent SER500784 Driveshaft Rear 69mm SRX2 Gen3

Price:

NZD$48.53

Brand:

Serpent

Model:

SER500784

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Compact 69mm Driveshaft Suited to SRX2 Gen3

The Serpent 69mm Rear Driveshaft is tailored for the SRX2 Gen3 to provide dependable drivetrain behaviour. It improves torque transfer and helps tidy up handling on technical circuits. Whether replacing an old shaft or stepping up your setup, this Serpent part is made for accurate fit and steady track performance.

Why Choose This Part

Compatibility: Designed specifically to mate with the SRX2 Gen3 layout.
Durability: Built from materials chosen to resist wear under race conditions.
Precision: Finished to ensure correct alignment and minimal driveline lash.

Can I fit this to a modded SRX2 Gen3 with different gear spacing?

It is made for the stock SRX2 Gen3 geometry. If you have altered gear spacing or mounted nonstandard bulkheads, check clearances and spline compatibility before fitting.

Will this change vehicle handling?

A tighter, stiffer driveshaft can give crisper power delivery and marginally firmer response. Handling differences are subtle but noticeable to drivers focused on consistency.

How often should I check the driveshaft?

Inspect it after heavy runs or impacts and during routine service intervals. Look for play, bends, and spline wear to avoid drivetrain problems.

Is this compatible with common hop-up parts?

Yes, it works with typical SRX2 Gen3 hop-ups that keep the original driveline layout. Verify part dimensions when mixing third party components.