Serpent 500800 Front Pivot Pin Brace for SRX2 Gen3 - Heavy Duty Steel  [SER500800]

Serpent SER500800 Pivot pin Brace Front Steel SRX2 Gen3
Price:
NZD$15.58
Brand:
Serpent
Model:
SER500800
Condition:
Brand New
Write a review

Strengthen Your SRX2 Gen3 Front End

The Serpent 500800 Front Steel Pivot Pin Brace offers a solid upgrade for SRX2 Gen3 kits, built to keep alignment tight and reduce wear at the front suspension. The steel construction is aimed at racers who run hard and want consistent geometry.

Why Fit a Steel Brace

Steel components resist deformation better than softer alloys, so a steel pivot pin brace holds shape under repeated loads. That predictability helps with lap-to-lap consistency and lowers replacement frequency.

Made for SRX2 Gen3 Fitment

This brace is specifically formed for SRX2 Gen3 mounting points, enabling a neat installation with minimal trimming. Proper fit means less time setting up and more time on the layout.

Installation Hints

Clean the area and check pivot pins before installation of the Serpent 500800. Tighten fixings evenly and recheck suspension geometry after fitting to ensure handling balance is unchanged.

In most cases the Serpent 500800 drops into the SRX2 Gen3 layout without trimming. Inspect mounting faces and pins to confirm clearance before final tightening.
A light medium-strength threadlocker can help prevent screws backing out under vibration, but choose one that allows future removal when servicing.
Steel is heavier than composite parts, so some added front-end mass is expected. Balance effects are usually small, but check handling and tweak setup if required.
Inspect pivot pins and mounting points regularly, especially after hard runs. Look for play or unusual wear and service as needed to maintain precise handling.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved