Serpent 500814 Carbon Front Shock Tower SRX4 Gen3 Lightweight Mount  [SER500814]

Serpent SER500814 Shock Tower Carbon Front SRX4 Gen3
Price:
NZD$57.80
Brand:
Serpent
Model:
SER500814
Condition:
Brand New
Write a review

Carbon Front Shock Tower Optimised for SRX4 Gen3

The Serpent 500814 Carbon Front Shock Tower is built to match the SRX4 Gen3 chassis and improve front end precision. Crafted from high-grade carbon fiber, it reduces flex and helps the car stay settled over technical sections.

Why Carbon Helps Track Performance

Carbon fibre combines low mass with high stiffness, which benefits lap to lap repeatability. It keeps the steering consistent and reduces unwanted chassis flex when running tight lines or bumpy surfaces.

Direct Fit Installation Details

This Serpent 500814 item installs as a bolt-on replacement for the SRX4 Gen3 front mount. Use the stock fixings and follow normal reassembly steps to get your car back on the circuit quickly.

Can I use this with aftermarket shock towers?

This tower is intended for the SRX4 Gen3 layout. If an aftermarket tower mimics the same mounting points it may work, but confirm measurements first.

Does the tower need reinforcement hardware?

No additional reinforcement is required; it is designed to use the existing hardware. Inspect screw threads and torque to spec when fitting.

How should I maintain a carbon shock tower?

Clean with a soft brush after runs, check for cracks or delamination, and avoid over-tightening screws to prevent crush on the carbon.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved