Serpent 500852 1.6mm Front Sway Bar for SRX4 Gen3 - Precision Setup  [SER500852]

Serpent SER500852 Anti-Roll Bar 1.6mm Front SRX4 Gen3
Price:
NZD$9.02
Brand:
Serpent
Model:
SER500852
Condition:
Brand New
Write a review

Serpent 500852 Sway Bar Upgrade for SRX4 Gen3 Chassis

The Serpent 500852 1.6mm front anti-roll bar is crafted to tighten chassis response on the SRX4 Gen3. It cuts body lean during quick direction changes so drivers can place the car more accurately through technical sections.

Sharper Turn-In and Stability

At a 1.6mm diameter, this sway bar provides a firm but forgiving feel that helps maintain tyre contact in mixed grip conditions. The result is crisper turn-in and improved mid-corner balance without destabilising the rear.

Easy Fitment for Gen3 Chassis

Made to match SRX4 Gen3 mounting layouts, the Serpent 500852 installs with standard hardware and works with common front-end linkages. It is a sensible upgrade for restoring worn components or refining handling for track sessions.

Can I run this bar on carpet and asphalt tracks?

Yes, the 1.6mm Serpent 500852 gives a useful balance for both higher grip carpet and slower asphalt surfaces, though small spring or camber tweaks may be beneficial per surface.

Is special tooling needed to install it?

No specialist tools are required; basic RC tools and standard mounting screws are all you need to fit the anti-roll bar to the SRX4 Gen3.

Will changing to this bar affect rear grip?

Adjusting front roll stiffness can change the car's balance, so expect to make small rear-end tweaks to regain your preferred neutral handling.

How long does it take to swap the bar on the pit bench?

Most experienced builders can swap the anti-roll bar in under 20 minutes, including basic checks and a quick test run.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved