Serpent 500857 24T Slipper Pulley - Performance Replacement  [SER500857]

Serpent SER500857 Slipper Pulley 24T FT SRX4 Gen3
Price:
NZD$35.23
Brand:
Serpent
Model:
SER500857
Condition:
Brand New
Write a review

High-Precision Slipper Pulley for SRX4 Gen3

The Serpent 500857 24T slipper pulley is produced to tighten drivetrain response on SRX4 Gen3 models. Its accurate profile helps preserve smooth power delivery during corner exits and acceleration phases.

Track-Friendly Performance

Built for the Spyder SRX4 Gen3, the 24T tooth count helps deliver a consistent balance of torque and speed for controlled lap times. The pulley is constructed to resist the wear common in frequent club running.

Direct Fit Installation

This component is a drop-in fit for Serpent SRX4 Gen3 layouts, so you can swap it in with standard drivetrain parts and minimal fuss for quick setup changes.

Specifications

  • Tooth Count: 24T
  • Compatibility: Serpent SRX4 Gen3
  • Material: High-Durability Composite

For racers wanting a dependable pulley to stabilise SRX4 Gen3 drive characteristics, this 500857 unit is a straightforward upgrade that lasts through repeated use.

Will the pulley change slipper behaviour?

The 24T pulley influences the torque curve and can alter slipper engagement slightly; pair it with correct slipper settings to dial in feel.

Are any special tools needed to fit it?

Standard hand tools used for SRX4 Gen3 drivetrain work are sufficient. Ensure shaft fit is correct and that fasteners are torqued to spec.

Is the material suitable for heavy use?

The high-durability composite is chosen to withstand repeated stress, but inspect after competitive events and replace if you see significant wear.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved