Serpent 500859 - 76mm DJC Driveshaft Set for SRX4 Gen3 Spyder Series Front Shafts [SER500859]

Price:

NZD$48.13

Brand:

Serpent

Model:

SER500859

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Accurate Front Shafts for Racing Chassis

The Serpent 500859 DJC Driveshaft Front 76mm set is crafted to sharpen handling and dependability on the SRX4 Gen3. As part of the Spyder Series, the set aims to preserve efficient power flow and steady control during laps.

Double Joint Layout for Reduced Drag

The double joint format lowers resistance at the joints and helps maintain a more uniform drive feel under acceleration and steering loads. With a 76mm specification, these shafts match SRX4 Gen3 clearance and alignment needs.

Specifications

Length: 76mm
Compatibility: SRX4 Gen3
Material: High-strength steel
Quantity: Set of 2

Can I run these on street-style surfaces?

They work on hardpack and smooth asphalt but keep in mind the steel joints will pick up wear if abrasive debris is present. Clean and lube after each session for best life.

Do these need any setup changes?

No chassis setup changes are usually required when replacing like-for-like; verify toe and camber after installation to confirm geometry remains correct.

What grease is recommended?

Use a light, non-silicone drivetrain grease that will not damage bearings or plastics and will handle the temperatures generated in racing conditions.

How do I check for wear?

Look for play in the joints, uneven rotation, or metal fatigue marks. Replace the shaft if any movement appears in the joint beyond minimal tolerances.