Serpent 600125 Cobra 811 Upright Set - Off-Road Tune  [SER600125]

Serpent SER600125 Upright Left + Right
Price:
NZD$22.18
Brand:
Serpent
Model:
SER600125
Condition:
Brand New
Write a review

Upgrade Your Cobra 811 Steering

The Serpent 600125 Upright Set fits the Cobra 811 Buggy as a direct left and right replacement, delivering a snug fit that reduces steering slop. Drivers will notice crisper turn-in and steadier tracking thanks to consistent geometry and reinforced contact points. Perfect for club racing or weekend off-road sessions where repeatable steering matters.

Built for Varied Surfaces and Consistent Handling

Produced from tough, serviceable materials, the Serpent 600125 Upright Set is intended to keep alignment true for the Cobra 811 series. The dimensions match original mounting points so you can swap uprights without changing suspension settings. With these fitted, your buggy will hold steering line across grass, gravel and packed dirt.

Is installation difficult for hobbyists?

Installation is simple for anyone familiar with basic buggy work. Remove the old uprights, press in bearings if needed, fit the new uprights and check steering alignment.

Can I move to stronger aftermarket uprights later?

The Serpent 600125 set is designed for durability, but aftermarket options are available if you want different materials. Ensure any upgrade matches Cobra 811 geometry before ordering.

Will these uprights alter camber or ride height?

They are made to preserve the original fit, so ride height and camber should remain the same when replacing like for like. Always recheck alignment after fitting.

Are bearings and pins included?

This listing is for uprights only. Bearings and small hardware are usually retained from your kit or purchased separately to match your preferred setup.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved