Serpent 600196 Precision Steel Coupler - Track Upgrade  [SER600196]

Serpent SER600196 Gear Coupler Steel
Price:
NZD$37.93
Brand:
Serpent
Model:
SER600196
Condition:
Brand New
Write a review

Precision Steel Coupler for Demanding Tracks

The Serpent 600196 Steel Gear Coupler is made to tighten up drivetrain response on competitive models. Crafted from quality steel and finished for a snug fit, it reduces drivetrain lash and keeps power delivery consistent lap after lap.

Why the Steel Coupler Helps Performance

Compared with softer stock parts, the Serpent 600196 resists deformation under load so gears remain aligned. That precision lowers wear on bearings and pinions, helping maintain predictable handling and throttle response.

Fitment Notes and Installation Tips

This coupler suits a range of RC platforms but always confirm shaft diameters and mounting interfaces before installation. Use correct thread lockers where specified and check the assembly after the first run to ensure everything beds in correctly.

How do I confirm it fits my buggy or touring car?

Measure your existing coupler or reference the parts diagram for your model. Compare shaft bore and overall length to the Serpent 600196 to verify compatibility before buying.

Is extra lubrication required for steel couplers?

The coupler itself is steel and typically does not need grease, but keeping surrounding joints and driveshaft bearings properly lubricated reduces noise and wear in the system.

Will upgrading this part reduce drivetrain maintenance?

Upgrading to a tougher coupler can lower the frequency of replacements, but regular checks of the whole drivetrain are still recommended to catch worn gears or shafts early.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved