Serpent 600238 Rear Antiroll Bar 2.5mm - Precision Handling Upgrade  [SER600238]

Serpent SER600238 Antiroll bar Rear 2.5mm
Price:
NZD$9.23
Brand:
Serpent
Model:
SER600238
Condition:
Brand New
Write a review

Tighten Rear Roll with Serpent 600238 2.5mm Bar

The Serpent 600238 rear antiroll bar helps deliver cleaner turn-in and steadier mid corner balance for RC cars. The 2.5mm diameter offers a practical tuning step for drivers wanting crisper rear response.

What a 2.5mm Bar Changes in Handling

An antiroll bar at 2.5mm raises rear roll stiffness enough to limit body lean while retaining suspension compliance for traction. That change improves cornering predictability across a variety of track surfaces.

Compatibility and Installation Notes

Manufactured to fit common rear link layouts, the Serpent 600238 is straightforward to fit and works well when replacing a worn part or upgrading from a thinner bar. Simple hardware swaps keep installation quick.

Will the 2.5mm bar make the car oversteer?

Increasing rear roll stiffness can shift balance toward oversteer on some setups. Tune springs and antiroll front rate if you notice excessive rear bite, and test in small increments.

Is special hardware required to fit this part?

Most installations use existing link pins and spacers, but confirm you have the correct ball studs and secure fasteners before fitting the Serpent 600238 to your chassis.

Which track conditions suit a 2.5mm bar?

The 2.5mm bar is versatile but works best on medium to high grip surfaces where limiting roll improves corner speed. On very low grip you may prefer a softer rear bar.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved