Serpent 600336 Front Antiroll Bar 1.8mm - Corner Control  [SER600336]

Serpent SER600336 Antiroll bar Front 1.8mm
Price:
NZD$10.07
Brand:
Serpent
Model:
SER600336
Condition:
Brand New
Write a review

Fine-Tune Front End with Serpent 600336

The Serpent 600336 Front Antiroll Bar targets RC enthusiasts aiming to improve steering precision and front-end balance. Its 1.8mm gauge is suited to drivers who want to tweak understeer and roll without over-stiffening the chassis. Produced to reliable tolerances, it supports consistent handling at speed.

How Serpent 600336 Shapes Your Setup

Fitting this antiroll bar reduces excessive body roll and stabilises turn-in, allowing tighter lines through corners. The added front rigidity can help maintain predictable grip levels when pushing pace on smooth or medium-grip surfaces.

Will the Serpent 600336 work on my touring car?

It is compatible with many touring and 1/10 scale on-road cars that use similar antiroll link setups, but confirm mount spacing and endlink style before fitting.

Should I run this bar on carpet or asphalt?

The 1.8mm bar works well on medium to high grip surfaces. For very low grip layouts you may prefer a softer bar to retain mechanical traction.

Can I tune handling without changing springs?

Yes. Swapping antiroll bar thickness is a common way to alter balance without changing spring rates, letting you fine-tune understeer or oversteer characteristics.

How often should I inspect the bar?

Check the bar and endlinks after hard sessions for signs of wear or loosening; routine inspection prevents sudden handling changes.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved