Serpent 600346 - Pro Series Brake Pad  [SER600346]

Serpent SER600346 Brake pad Pro
Price:
NZD$25.26
Brand:
Serpent
Model:
SER600346
Condition:
Brand New
Write a review

Consistent Braking for Club and Weekend Racing

The Serpent SER600346 Pro Brake Pad is aimed at enthusiasts who demand steady braking response. Crafted from quality friction compounds, this pad gives dependable stopping power while resisting rapid wear. It suits those upgrading their braking system or doing routine maintenance to keep performance predictable.

Stable Performance Under Load

The pad is engineered to maintain optimal friction under high loads, helping drivers control speed into tight corners. Its durable makeup resists wear and keeps braking characteristics stable during extended runs.

Compatibility Notes and Installation Tips

Serpent Pro Brake Pads fit a variety of RC chassis and install with standard hardware. Check pad thickness and alignment during installation to achieve even contact and consistent braking feel.

Can I use this pad on a mixed-surface layout?

The Serpent SER600346 is optimised for smooth surfaces but will function on varied surfaces depending on conditions. Expect different wear rates on abrasive layouts.

Any special tools required for fitting?

Installation is generally straightforward using common hand tools. A torque-controlled driver and a feeler gauge help ensure correct pad clearance and alignment.

How do I maintain even wear across the pad?

Regular checks for rotor runout and caliper alignment will promote even wear. Rotate pads if the design allows and replace if one side shows excessive wear.

Is there any break-in procedure recommended?

A gentle bedding-in routine of progressive braking helps mate the pad to the rotor and avoids glazing. Short runs with moderate braking are usually sufficient.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved