Serpent 600380 Rear Gear Coupler with Clip - Off-Road Ready  [SER600380]

Serpent SER600380 Gear coupler rear + clip
Price:
NZD$74.84
Brand:
Serpent
Model:
SER600380
Condition:
Brand New
Write a review

Accurate Rear Drive Coupler

The Serpent 600380 rear gear coupler with clip is built to offer a precise interface between motor and drivetrain in RC race and off-road models. Its accurate fit helps keep power delivery consistent during demanding runs.

Compatibility and Toughness

Produced from quality materials, the Serpent gear coupler stands up to frequent use and rough conditions. The geometry supports a wide selection of chassis types, making it a flexible upgrade for hobbyists.

Service and Performance Upgrades

For routine servicing or when upgrading drivetrain parts, the Serpent rear gear coupler makes replacement straightforward while helping to preserve smooth operation and drivetrain balance.

How do I check fitment before buying the Serpent 600380?

Measure your output shaft diameter and spline pattern and compare them to the part you have. Confirming these dimensions prevents fitment issues.

Is any special tooling needed to install the coupler?

Installation generally requires basic hand tools for clip removal and a careful press on the shaft. No specialised machining is normally required.

Will this part suit both carpet and dirt tracks?

The coupler is suitable for a variety of surfaces since it focuses on secure power transfer, though tuning and other drivetrain parts also influence handling on different tracks.

Any tips for extending coupler life?

Regular inspection for wear, clean installation, and replacing clips or worn mates promptly will help keep the coupler performing longer.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved