Serpent 600401 - S811 Off-Road Truggy Shell [SER600401]

Price:

NZD$79.24

Brand:

Serpent

Model:

SER600401

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Lightweight Replacement Shell for S811 Truggy

The Serpent 600401 - S811 is a replacement body shaped to match the S811 Truggy profile while offering resilient protection. Produced from quality polycarbonate, it delivers a balance of durability and low mass so the truggy retains predictable handling. A sensible option for those repairing a dented shell or fitting a fresh, factory-style cover.

Specifications

Material: Polycarbonate
Compatibility: Serpent S811 Truggy

A straightforward shell swap that keeps the S811 looking sharp and protected on rough surfaces.

Does this fit the original Serpent S811 mounts?

Yes, this body is cut for the S811 body post layout and should align with factory mounting points without modification.

What painting method works best?

Spray polycarbonate paints on the inside, using light, even passes and allowing full cure times to avoid runs and maintain flexibility.

Should I trim any areas before running?

Check wheel clearance and servo linkages after mounting; a small amount of trimming around wheel wells may be needed depending on your tyre choice.

How often will I need to replace the shell?

Replacement frequency depends on use and impacts; racers may replace more often, while casual drivers can expect longer service with repairable scuffs.