Serpent 600437 Steering Ball Joint & Lever for 811-E Club Racer Upgrade  [SER600437]

Serpent SER600437 Steering Balljoint + Lever 811-E
Price:
NZD$17.39
Brand:
Serpent
Model:
SER600437
Condition:
Brand New
Write a review

Responsive Steering Upgrade for 811-E

The Serpent 600437 steering balljoint and lever bring tighter steering feel and enhanced control to the Serpent 811-E platform. This upgrade helps drivers achieve more predictable turn-in and better front end feedback.

Engineered for Longevity

Using quality materials, the Serpent 600437 assembly is built to resist wear and preserve alignment under repeated use. Consistent steering geometry keeps lap times steady and reduces mid-run changes.

Straightforward Fitting Procedure

Designed to match the Serpent 811-E mounting points, the part installs with minimal fuss so you can get back on track quickly. The precise dimensions reduce the need for trial and error during setup.

Can I use this on older 811 variants?

It is intended for the Serpent 811-E specification. If you have an older variant, compare mounting points and dimensions before fitting to avoid geometry issues.

What maintenance keeps performance optimal?

Regularly clean the joint, check for play and lubricate contact points as needed. Replace worn pins or bearings to maintain steering accuracy.

Will this change my steering geometry?

The part is made to preserve the factory geometry on the 811-E. Minor toe or caster tweaks may still be needed to fine tune handling.

Is this compatible with standard servos?

Yes, it works with typical RC steering servos used on 1/10 touring and buggy builds. Ensure your servo linkage length matches the setup for best results.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved