Serpent 600494 +3mm Lightweight Hex Wheel Upgrade  [SER600494]

Improve Track Balance with the Serpent 600494 Wheel Hex

Hobbyists wanting finer handling will find the Serpent 600494 Wheelhexagon Light +3mm kit a practical modification. The set contains a pair of light wheel hexagons plus the required nuts and pins, delivering a consistent +3mm offset to help the vehicle track truer through bends.

Precision Fit for Improved Grip

Built to maintain close tolerances, these hexagons add three millimetres of track width which aids lateral grip and reduces body roll. That extra stance is noticeable on technical circuits and during fast direction changes.

At-a-Glance Features

• Brand: Serpent
• Offset: +3mm to increase stability
• Compatibility: Works with many standard RC wheel hubs
• Includes: 2 wheel hexagons, nuts, and pins

Fitment Hints and Setup

Fitting the Serpent 600494 parts is a quick swap: remove your current hexagons and replace them with these lightweight units, making sure the nuts and pins are fastened properly. Re-check tightness after a short run, and fine-tune alignment for the best handling balance.