Serpent 600533 Centre Front Driveshaft for 811-S Race Setup [SER600533]

Serpent SER600533 Driveshaft Center Front 811-S

Price:

NZD$27.76

Brand:

Serpent

Model:

SER600533

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Precision centre driveshaft built for Serpent 811-S

The Serpent 600533 Centre Front Driveshaft is engineered to support the Serpent 811-S chassis with consistent torque transfer and long service life. Its precise machining helps reduce driveline lash for improved throttle control on the track.

Highlights of the Serpent 600533 centre shaft

Compatibility: Tailored for the Serpent 811-S to ensure a correct match and straightforward installation.
Longevity: Manufactured to tolerate repeated race use and routine maintenance cycles.
Drive quality: Optimises power flow to the front end for smoother acceleration and better cornering balance.

Is special lubrication needed for the splines?

Light, long-lasting grease on the splines helps prevent wear and noise. Avoid excess that can attract grit during off-road use.

Can I use the Serpent 600533 with aftermarket diffs?

It mates to the 811-S driveline layout; compatibility with third-party diffs depends on shaft interfaces and mounting points, so check measurements before swapping parts.

What signs indicate the driveshaft needs replacing?

Noticeable play at the joints, persistent vibration, or visible wear on splines are common indicators that replacement is required.

Any tips for setup after fitting?

After fitting, verify driveshaft alignment and check for binding through full suspension travel. Recheck fasteners after a short test run.