Serpent 600549 Rear Suspension Bracket for 811-S Precision Fit  [SER600549]

Serpent SER600549 Suspension Bracket FR-Rear 811-S
Price:
NZD$14.73
Brand:
Serpent
Model:
SER600549
Condition:
Brand New
Write a review

Rear End Strength for Serpent 811-S

The Serpent 600549 bracket is tailored to the 811-S chassis to boost rear rigidity and keep suspension points correctly aligned. It is aimed at drivers who want steadier handling through corners and under braking.

Durable Construction for Track Use

Produced from high quality materials with tight tolerances, this bracket reduces unwanted flex and preserves suspension geometry. That translates into more predictable traction and easier setup tuning lap after lap.

For Tuners and Club Racers

Whether refining camber and toe or seeking consistent rear behaviour at the limit, the Serpent 600549 supports precise adjustments while surviving the demands of competitive running.

Is this bracket a direct replacement for the stock part?

Yes, the bracket is designed to replace the original rear bracket on the 811-S, using the same mounting points and hardware pattern.

Will it change handling dramatically?

Expect improved consistency rather than radical change; the main benefit is reduced flex and steadier suspension geometry for cleaner cornering.

Any special tools needed to fit it?

No special tools are required beyond common RC hand tools. Use a calibrated driver for final screw torque to avoid over tightening.

Can I run this bracket on different surfaces?

The bracket is suitable for a variety of surfaces, from carpet and asphalt to prepared outdoor tracks, as it focuses on preserving suspension geometry.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved