Serpent 600554 Pivot Ball Short Steering Set for 811-S - Precision Kit  [SER600554]

Serpent SER600554 Pivot Ball Steering Short 811-S (2)
Price:
NZD$15.48
Brand:
Serpent
Model:
SER600554
Condition:
Brand New
Write a review

Refine your steering with the Serpent 600554 upgrade

The Serpent 600554 Pivot Ball Steering Short Set is aimed at hobbyists running the 811-S series who want crisper steering input and improved feedback. Manufactured to match the original mounting points, these pivot balls help tidy up steering response without major chassis changes.

What the Serpent 600554 steering set brings to your 811-S

Specifically matched to the 811-S series, this short set installs cleanly and is made from materials selected for durability. Expect a more consistent steering feel and reduced slop during tight turns and on uneven surfaces.

Can I swap these into older 811 variants?

These pivot balls are specified for the 811-S series geometry. Older variants may fit but you should verify ball seat dimensions and linkage clearances before fitting.

Do they change wheel alignment?

The short set is intended to retain your existing alignment settings. After installation, check toe and steering endpoints and adjust as needed to restore factory setup.

Are these suitable for off road use?

They are built for durability and will handle rougher surfaces typical of off road running, though routine inspection after heavy sessions is recommended.

What tools do I need to fit them?

Basic RC tools such as hex drivers, pliers and a small wrench set are usually sufficient to remove the old parts and fit the Serpent 600554 pivot balls.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved