Serpent 600651 Front Spring Set - Precision Green Coating  [SER600651]

Serpent SER600651 Spring Front Green V2 (0 81N/4 65LB) (2)
Price:
NZD$13.81
Brand:
Serpent
Model:
SER600651
Condition:
Brand New
Write a review

Refine Front End Response with Serpent 600651 Springs

The Serpent 600651 Front Spring Set is aimed at hobbyists who want tighter suspension control. Made for high-performance 1/10 scale vehicles, these springs strike a balance between strength and flex for reliable handling.

Measured Rate for Accurate Setups

Each spring is produced to a measured 0.81N/4.65LB rate to help you make accurate tuning choices. The green finish protects the wire and keeps the springs looking good through regular use.

Where These Springs Work Best

These front springs suit many 1/10 scale chassis and are useful on sealed surfaces and prepared dirt. They give a predictable front characteristic, making setup changes easier during practice sessions.

Will these springs fit my 1/10 touring car?

Most 1/10 touring car front assemblies accept these springs, but check your shock shaft length and spring perch dimensions before fitting to ensure correct preload range.

How should I test them on track?

Make one setup change at a time, such as swapping springs while keeping shocks and oil the same, then run short test laps to feel differences in turn-in and mid-corner stability.

Do the green springs need special care?

Wipe off grit after runs and check for nicks in the coating. The finish helps resist wear but basic cleaning and inspection will extend their service life.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved