Serpent 600714 Front Suspension Bracket for 811GT - Precision Replacement  [SER600714]

Serpent SER600714 Suspension Bracket Front Front 811GT
Price:
NZD$58.42
Brand:
Serpent
Model:
SER600714
Condition:
Brand New
Write a review

Precision Front Mount for 811GT

The Serpent 600714 Front Suspension Bracket is tailored for the 811GT chassis to give a refined, accurate fit. Its design focuses on repeatable alignment and resilience for both race days and routine servicing.

How It Improves Handling

From Serpent's engineering bench, this bracket tightens up front-end geometry to reduce flex and improve response. It is intended to offer consistent handling without altering the car's original setup philosophy.

Specifications

  • Compatibility: Fits the 811GT chassis
  • Material: High-strength composite
  • Function: Provides reinforced suspension support

A practical upgrade for workshop repairs or performance tuning, the Serpent 600714 bracket helps keep the 811GT running true and predictable on the track.

Can I use this bracket on carpet and asphalt tracks?

Yes. The bracket strengthens the front end for a variety of surfaces, though you should tune suspension and tyres to match the track conditions.

Will I need new mounting hardware?

The part uses the 811GT mounting points. In many cases you can use the kit hardware, but inspect screws for wear and replace any that are rounded or damaged.

Any setup checks after fitting?

After installation, verify wheel alignment and steering geometry, and recheck fastener tightness after a few runs to ensure everything seats correctly.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved