Serpent 600738 Competition-Grade Steel Skid Plate for SRX8  [SER600738]

Serpent SER600738 Skid Plate Steel SRX8
Price:
NZD$19.60
Brand:
Serpent
Model:
SER600738
Condition:
Brand New
Write a review

Steel Protection Plate for SRX8 by Serpent

The Serpent 600738 Steel Skid Plate protects the lower surface of the SRX8 chassis from rocks, tarmac scrapes and hard landings. Crafted from tough steel, it resists wear and maintains structural integrity under repeated impacts.

Main Advantages of This Skid Plate

Designed to sit flush with SRX8 mounting points, the plate installs cleanly and keeps service time low. The mass of the steel contributes to a steadier ride and can improve traction by shifting the centre of gravity lower. Ideal for hobbyists who want reliable protection without complex fitting.

Can I use this plate with aftermarket belly pans?

It is optimised for the SRX8 factory layout; combining it with other belly pans may need trimming or different mounting hardware.

Will the skid plate change suspension behaviour?

Slightly increased mass under the chassis can alter rebound and balance. Many users tune spring rates or damping to compensate for the weight shift.

How should I maintain the steel plate?

Wipe clean after salty or muddy runs, check for bends or sharp edges and replace if deformation compromises mounting or ground clearance.

Is drilling required for cable routing?

Most setups do not require extra holes, but if you need to route cables you can carefully drill using the correct pilot bits and protect cabling with grommets.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved