Serpent 600746 - SRX8 Brake Cam Wire Set Track Tuning Wires  [SER600746]

Serpent SER600746 Brake cam Wire Front + Rear SRX8
Price:
NZD$6.69
Brand:
Serpent
Model:
SER600746
Condition:
Brand New
Write a review

SRX8 Brake Precision Upgrade

For competitive RC enthusiasts focused on braking control, the Serpent 600746 - SRX8 Brake Cam Wire Set is a practical upgrade. It is made to match the SRX8 chassis and improve consistency under race conditions.

Contents and Build Notes

The Serpent 600746 - SRX8 Brake Cam Wire Set comes with matched front and rear wires purpose made for the SRX8. Built to resist stretch and wear, the kit helps maintain stable brake input and predictable deceleration.

Benefits for Setup and Tuning

Upgrading brake linkages can change lap consistency and corner approach. Serpent's brake cam wires give tuners a stable platform to adjust bias and brake travel on the SRX8.

Can I use these with aftermarket calipers?

Fit depends on mounting geometry. The set is made for SRX8 stock layout, so check caliper anchor positions before swapping parts.

Is installation difficult for a club racer?

Basic mechanical skills and common tools are enough. Follow a step by step approach and test adjustments on a slow run before race use.

How do these wires affect brake modulation?

The precision fit reduces slack and gives sharper modulation, making it easier to dial in progressive braking through corners.

Any tips for long term care?

Keep contact points clean and avoid overbending the wires. Replace them if you notice deformation or loss of smooth action.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved